The escape chute is mainly used for rescuing people from high buildings when a fire happened where elevator or other equipment can’t be used. It has become a mandatory condition for safety escape from high buildings.
It is suitable for any places from a high position which can be used by both adults and children.
This LS-EC-60 serious belongs to hopper type escape chute as the most popular one with long lifetime of 10 years.
（1）Cloth of three layers consist the chute with different performances of outter fire resisting, middle heat thermal resisting & inner slide guidance;
（2）Many pieces of elastic rubber rings on suitable places of chute to maintain slow falling speed;
（3）Storage tank made up of 304 stainless steel material to keep the chute clean and safe for storage.
（1）Hopper type chute can increse resistance during falling to slow down the speed for safer escape;
（2）100% inflame retardant aramid material for three layers’ clothing;
（3）Single set of escape chute can be used on any high place not higher than 50m;
（4）Rescue position higher than 50m can be used by more than 1 setsd of escape chute combined;
（5）Victims won’t feel fear since can’t see ground during falling;
（6）No need of electricity for operating, only manual is enough;
（7）Very simple operation steps which is suitable for people of all ages;
（8）Babies are also fine being held by adults, children can ride adult for escaping.
304 Stainless Steel Tank | |
Volume | 705*710*1190mm |
Tank Cap | 740*745*60mm |
Material | 304 Stainless Steel |
Wall Thickness | ≥1.2mm |
Surface Treatment | Mechanical Polishing & Professional Processing on Surface |
Life Time | 60years |
Note: Storage environment should be non-corrosive & no rust, otherwise would shorten life time | |
Chute Cloth | |
Layers | Outer Layer: Fire Resisting Middle Layer: Heat Thermal Resisting Inner Layer: Slide Guide Layer |
Diameter of Cloth Circle | ϕ 600mm |
Stitches Density | 8 Stitches Per 30mm Length |
Afterflame Time | ≤1s |
High Temperature Resisting | Max. 600℃ |
Breaking Strength | ≥1000N |
Shearing Strength | ≥130N |
Joint Strength | ≥700N |
Rate of Elongation | ≥1% |
Elastic Rubber Rings | |
Hardness | 58 Shore A |
Tensile Force | 16MPa |
Rate of Elongation Tensile | 600% |
300% Anchoring Force | 8Mpa |
Diameter of Rubber Rings | ϕ 200mm-600mm |
Width of Rubber Rings | 20mm |
Distance between Each Two Rubber Rings | 50cm |
Changing Rate of Pulling Strength being Oxidized by Hot Air | -10.5% |
Changing Rate of Tensile Strength being Oxidized by Hot Air | -10% |
Changing Rate of Hardness being Oxidized by Hot Air | 63 Shore A |
Components | Unit | Weight |
Chute | 1mtr. Length | 1.8kg |
Entrance Diameter | 1pc | Φ540mm |
Descent Control Device | 1unit | 7.4kg |
SS Tank | 1unit | 105kg |
Outside Wooden Case (1177*1000*800mm) | 1unit | 40.6kg |
